How to Install Asphalt Roll Roofing
Installing asphalt roll roofing is a cost-effective and relatively straightforward process that can be completed by most homeowners with some basic tools and materials. This type of roofing is popular for its durability, ease of installation, and affordability. In this article, we will guide you through the steps required to install asphalt roll roofing on your home.
Materials and Tools Needed
Before you begin the installation process, gather all the necessary materials and tools. Here’s a list of items you’ll need:
– Asphalt roll roofing
– Roofing felt or underlayment
– Roofing nails or staples
– Utility knife
– Roofing hammer
– Chalk line
– Level
– Trowel
– Ladder
– Safety gear (gloves, goggles, etc.)
Preparation
1. Remove Old Roofing: If you’re replacing an existing roof, start by removing the old shingles. Be sure to dispose of them properly according to local regulations.
2. Check the Deck: Inspect the roof deck for any damage or weak spots. Repair any necessary areas before proceeding with the installation.
3. Install Underlayment: Lay down a layer of roofing felt or underlayment over the roof deck. This provides an extra layer of protection against moisture and wind uplift.
4. Attach Underlayment: Secure the underlayment to the roof deck using roofing nails or staples. Overlap the edges by at least 2 inches to ensure a tight seal.
Installation Process
1. Start at the Bottom: Begin installing the asphalt roll roofing at the lowest point of the roof, such as the eaves or valleys.
2. Overlap Shingles: Overlap each shingle by at least 2 inches to prevent leaks. Be sure to align the shingles with the existing ones for a uniform appearance.
3. Secure Shingles: Use a roofing hammer and nails or staples to secure the shingles to the roof deck. Place the nails or staples about 1 inch from the edge of the shingle and 3/4 inch from the top edge.
4. Trim and Cut: As you progress, trim and cut the shingles to fit around roof edges, vents, and other obstructions.
5. Install Ridge Cap: Once the shingles are in place, install a ridge cap along the top of the roof. This provides additional protection and completes the roofing installation.
Final Touches
1. Sealant: Apply roof sealant around all nails, vents, and other openings to prevent leaks.
2. Inspection: Perform a final inspection of the roof to ensure everything is properly installed and secure.
3. Maintenance: Regularly inspect and maintain your asphalt roll roofing to ensure its longevity.
By following these steps, you can successfully install asphalt roll roofing on your home. Remember to take your time and be patient throughout the process, as proper installation is crucial for the roof’s performance and durability.
